Abstract
In order to improve the measurement performance of dry calibration on ultrasonic flowmeter, the Computational Fluid Dynamic (CFD) modeling approach of the effect on transducer protrusion and recess are mainly discussed in the paper while its effects on ultrasonic flowmeter accuracy are also presented. Through comparing simulation results to experimental data, the CFD modeling is firstly determined. Then, detail analysis on flow field for two typical transducer installations are obtained based on the CFD method. Besides, the mechanism of both flow effects on measurement accuracy are explained and compared respectively, which indicates that negative velocities generated at protrusion and recess locations are the indispensable factors for negative measurement errors. Finally, comparison results show that smaller measurement error can be achieved with protruding transducers, which is a better arrangement type of transducer for ultrasonic flowmeters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
