Abstract
Electric energy meter wiring error variety, detection method and circuit can only detect some kinds of wrong wiring at present, as the current transformer and current detection unit terminal short-circuit characteristics of conventional methods in existence, not take out stitches under the premise of not achieving detection. Based on this, this paper puts forward a step detection method, detection circuit of voltage and current lines one by one through right off and polarity of current, gradually show every junction point junction and the fault point. Through the Multisim software simulation, and developed a set of wire detecting device, simulation and experimental results prove that the method is correct. Compared with conventional methods, can be more comprehensive and faster connection detection fault location. DOI: http://dx.doi.org/10.11591/telkomnika.v14i1.7662
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: TELKOMNIKA Indonesian Journal of Electrical Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
