Abstract
Polystyrene (PS) is an important commodity plastic; however, it is not known as a suitable material for tribological applications. It has a relatively high friction coefficient in contact with metallic surfaces and high abrasion loss factor. Polytetrafluoroethylene (PTFE) is a known friction modifier, has a low friction coefficient, and is extensively used to reduce the friction coefficient and wear rate (with engineering plastics to improve tribological properties). It is known for fluoroelastomers and engineering plastics that fine particles of PTFE have the greatest effect on improving the specified properties. Here, oriented, fibrillated network morphology of PTFE in PS matrix was prepared. The wear studies show a large reduction in both the friction coefficient (45% reduction) and the wear rate (2% incorporation of PTFE leads to a 49% reduction). But the friction coefficients do not show any significant change on increasing PTFE. A similar observation was made for the wear rate. Scanning electron microscope (SEM) images of the worn surfaces show a crack tip bridging mechanism, and it was observed that with the increase in PTFE content, the extent of crack tip bridging increases. This extensive improvement may be attributed to the unique morphology of the blend system.
Highlights
Blending of polymers is mixing of two or more polymers or copolymers to modify the material property to suit any desired end application in a fast and inexpensive route
In case of 10% TSAN filled composite (T10PS, Figure 2(b)), a new feature, that of fibrils, which is completely absent in 4% TSAN loaded samples (T4PS, Figure 2(a)), is observed
It is difficult to get an idea about the length of the fibrils, because at the fracture surface there is a chance of fibril breakage, and in the case of networks, it is difficult to ascertain the length of the fibrils
Summary
Blending of polymers is mixing of two or more polymers or copolymers to modify the material property to suit any desired end application in a fast and inexpensive route. There are mainly three different routes of making polymer blends: solution casting, emulsion mixing, and melt mixing. Morphology development in blends is a process of evolution of spatial geometry or arrangement of the phases of the constituent polymers. It would be very desirable if the morphology could be controlled by the blending operation, since that would impart a higher degree of control over the final property of the blend. There is significant research being conducted on polymer tribology; the basic understanding of polymer tribology is still insufficient, such as the relationship between hardness and wear properties [1]
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
