Abstract
Conventional calculation of rolling load has been treated on the basis on the assumption of two-dimentional deformation, but such an assumption cannot be used for the hot rolling practice in which the ratio of width to the thickness of material is smaller than 20, when the lateral spread occurs. The author developed the three-dimensional consideration of rolling stresses and spread during the rolling in previous report. Using these results, the author obtained a new formula of rolling load in hot states as follows : [numerical formula] In this report the calculated results were presented for various rolling conditions.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Transactions of the Japan Society of Mechanical Engineers
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
