Abstract
High impact polystyrene sheets (HIPS) of 1.5 mm and 2.5 mm thicknesses were thermoformed on moulds of different parameters at sheet heating temperatures of 130℃ and 140℃. Formability studies indicated no difference in wall thickness distribution at different sheet temperatures. Due to non-uniform stretching of the sheet, wall thickness distribution along the slant length was found to have three regions. In the regions near the mould corner and clamp point, wall thickness was found to decrease with increase in distance from the corner, in these zones. The decrease near the corner was much greater and sharper than that near the clamp point. The decrease in both regions was found to increase at higher depths of draw and decrease at higher draft angles. In the intermediate portion of the slant length, no significant variation in wall thickness was observed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
