Abstract
We have investigated experimentally by electric wire strain gauges the stress distribution in the T-section beams in the case of bending loads, when they were supported at both ends and carrying a centrally concentrated load as the upper chord members of E.O.T. Crane girders. The principal results of the investigation may be summarized as follows : (1) The near part of the loaded point of the upper horizontal plate (flange plate) has a tendency to bend separately from the total bending state. (2) The reduction ratio of strength of the T-section beam was about 10∼20%, in which the width of flange plate is smaller than three times the depth of web plate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Transactions of the Japan Society of Mechanical Engineers
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
