Studies on the microstructure and mechanical properties of AlCu4MgSi aluminum alloy repaired via electron beam directed energy deposition

Abstract

Additive manufacturing (AM) technologies have been used to repair aluminum (Al) alloy components in many engineering structures. However, the use of AM technologies to repair Al-Cu alloys is still very limited, and the repair via electron beam directed energy deposition (EB-DED) has not been reported so far. In this work, the EB-DED repair was performed on AlCu4MgSi-O Al alloy substrate with the specially developed Al-Cu-Si wire (380D). The results show that wall structures with high metallurgical quality were successfully prepared. The deposit exhibits alternating fine grain zones and coarse grain zones. In the bottom layers of deposit, columnar grains growing along building direction dominate, while the middle and top layers mainly consist of equiaxed grains. In the AlCu4MgSi-O substrate, the heat-affected zone (HAZ) close to the fusion line undergoes recrystallization and completely transforms into fine equiaxed grains, while abnormal grain growth occurs and coarse grains are formed in the HAZ slightly away from the fusion line. From substrate to deposit, the intensity of texture gradually decreases. After EB-DED repair, the microhardnesses and strengths of the bottom layers and HAZ are significantly improved. The strengthening of HAZ is entirely attributed to precipitation strengthening, while the bottom layers are affected by both precipitation strengthening and dispersion strengthening. Tensile tests indicate that the repaired structure samples fracture from the interface between HAZ and base metal zone of the AlCu4MgSi-O substrate. EB-DED is demonstrated to be a promising technology to repair AlCu4MgSi alloy components, and this work can serve as a useful reference for the high-quality repair of Al-Cu alloy structural parts.