Studies on the biaxial stretching of polypropylene film. XI. Type II orientation during [2‐2FI]‐type stretching and its change by subsequent thermal contraction

Abstract

AbstractIn order to study the deformation mechanism of type II stretching, the change in orientation during the restretching and subsequent thermal contraction was investigated by x‐ray diffraction method. When a uniaxially oriented film is restretched, the lamellae which are stacked in the stretching direction by the stretching rotate as a whole toward the restretching axis. They rotate backward nearly reversibly during the thermal contraction, unless the restretching exceeds a balancing state, where the orientation in the film plane are equal in all directions. However, when the restretching degree is so high and the film orientation exceeds the balancing state, the lamellar rotation is accompanied by a complex phenomenon. It is considered from the wide‐angle and small‐angle x‐ray diffraction patterns that the lamellar surface becomes indented because of slippage between microfibrils composing the lamellae, and the microfibrils themselves bend at the boundary between the amorphous and crystalline regions within which the tilting of c‐axis also occurs. Upon contracting of the film; these changes recover, but even in the last stage of contraction the orientation approaches the symmetrical biaxial orientation but not the uniaxial orientation from which the biaxial orientation is started. These orientation and disorientation behaviors are not affected basically by a slight change in the restretching temperature and the degree of stretching.