Abstract
High strength stainless steel wire mesh-polymer mortar reinforcement method was a kind of advanced reinforcement technique.The present study attempted to do a model analysis on the test of the high strength steel wire mesh-polymer mortar reinforcement of less stress beams by using finite element software ANSYS. The study was conducted through the analysis of the three factors of the tested bending reinforcement beam’s deflection, deformation and stress and comparison of the changes of the beam’s ultimate load and failure mode before and after reinforcement.The results of ANSYS analysis and the test showed that the failure mode shifts from less reinforcement damaged into reinforcement destruction;the crack loading value of the reinforced beams increased indicating that the beam bottom reinforcement layer had a significant effect on the increase of the beam’s crack loading. Increased significantly compared to non-reinforced ultimate bearing capacity of reinforced beams. the ANSYS finite element simulation agrees well with the experimental value.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.