Abstract

To improve the low antimicrobial activity of LF11, an 11-mer peptide derived from human lactoferricin, mutant sequences were designed based on the defined structure of LF11 in the lipidic environment. Thus, deletion of noncharged polar residues and strengthening of the hydrophobic N-terminal part upon adding a bulky hydrophobic amino acid or N-acylation resulted in enhanced antimicrobial activity against Escherichia coli, which correlated with the peptides' degree of perturbation of bacterial membrane mimics. Nonacylated and N-acylated peptides exhibited different effects at a molecular level. Nonacylated peptides induced segregation of peptide-enriched and peptide-poor lipid domains in negatively charged bilayers, although N-acylated peptides formed small heterogeneous domains resulting in a higher degree of packing defects. Additionally, only N-acylated peptides perturbed the lateral packing of neutral lipids and exhibited increased permeability of E. coli lipid vesicles. The latter did not correlate with the extent of improvement of the antimicrobial activity, which could be explained by the fact that elevated binding of N-acylated peptides to lipopolysaccharides of the outer membrane of gram-negative bacteria seems to counteract the elevated membrane permeabilization, reflected in the respective minimal inhibitory concentration for E. coli. The antimicrobial activity of the peptides correlated with an increase of membrane curvature stress and hence bilayer instability. Transmission electron microscopy revealed that only the N-acylated peptides induced tubular protrusions from the outer membrane, whereas all peptides caused detachment of the outer and inner membrane of E. coli bacteria. Viability tests demonstrated that these bacteria were dead before onset of visible cell lysis.

Highlights

  • Lactoferricin-derived E. coli Membrane Active Peptides antimicrobial activity

  • Proline was introduced to provide a rapid and efficient acid-labile Asp-Pro bond for its isolation from the fusion protein, if produced by recombinant techniques [29]. The structure of this peptide in lipidic environment was recently solved showing that Pro forms an essential part of the hydrophobic cluster with Phe2 or Trp3 [29], which has a similar function on the structural organization of the peptide as the acyl chain of the lipopeptide N-lauryl-LF11 [30]

  • Biophysical studies revealed that on a molecular level nonacylated and N-acylated peptides exhibited different effects on the structure of phospholipid model membranes representative for the cytoplasmic membrane of E. coli, which is reflected in the following models

Read more

Summary

EXPERIMENTAL PROCEDURES

Lipids and Peptides—1,2-Dipalmitoylphosphatidylglycerol (sodium salt) (DPPG), 1-palmitoyl-2-oleoyl-sn-glycero-3phosphoethanolamine (POPE), and E. coli total membrane lipid extract (58% phosphatidylethanolamine (PE), 15% phosphatidylglycerol, 10% cardiolipin, and 17% other) were purchased from Avanti Polar Lipids, Inc., and used without further purification. Purity (Ͼ99%) was checked before and after experiments by thin layer chromatography using CHCl3/CH3OH/ NH3 (25% in water) (65:25:5, v/v/v) as mobile phase and detection with molybdenic acid, a phosphorus-sensitive reagent [16]. Peptides in their amidated form (see Table 1) were purchased from PolyPeptide Laboratories, San Diego. The fluorescence measurements were performed in quartz cuvettes in 2 ml of the iso-osmotic buffer at the referred temperature. The fluorescence increase due to leakage and subsequent dilution of dye was measured after addition of peptides in three concentrations of 2, 4, and 8 ␮M, corresponding to peptide to lipid molar ratios of 1:25, 1:12.5, and 1:6.25, respectively. Data are presented in terms of fluorescence intensity (IF) in Equation 1, IF ϭ

F Ϫ F0 Fmax Ϫ F0
RESULTS
DISCUSSION
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call