Abstract
AbstractIn the past years studies were conducted on natural fibre reinforced polymer composites to observe their mechanical properties in order to decide their industrial applications. These composites have already been used in many applications from aerospace to sporting equipment. These green composites can be used as a replacement for synthetic composites. This is because the natural fibres are eco‐friendly, biodegradable, renewable, etc. In this work, an attempt is made to reinforce fly ash, coir fibre and sugarcane fibre with epoxy polymer matrix. Central composite design under response surface methodology (RSM), one of the approaches of design of experiments (DOE) is used to determine optimum sample preparation conditions of fly ash, coir fibre and sugarcane fibre. Both tensile and flexural (three‐point bending) tests are conducted on these fabricated composites to determine their materialistic characteristics. Analysis of variance (ANOVA) is carried out using Minitab software to find the influence of fly ash, coir fibre, sugarcane fibre on composites. Regression equations obtained from analysis of variance is used to calculate values. Experimental and calculated values are compared and their error % are calculated and tabulated. Response surface optimization study is carried to find the optimized parameters of composites. It is observed that, increase in wt.% of coir fibre and decrease in wt.% of fly ash and sugarcane fibre, increases yield stress and these parameters have mixed impact on ultimate tensile stress. The addition of fly ash, coir fibre and sugarcane fibre in low percentages increases Young's modulus. Increase in wt.% of fly ash and coir fibre and decrease in wt.% of sugarcane, increases flexural modulus and flexural stress.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have