Abstract
Bovine dentin was cut by hand with carbide burs and two cutting procedures while the rotational handpiece speed and the applied load were simultaneously monitored. It became evident that the maximum applied load during intermittent cutting varied from approximately 30 to 40 gm, whereas that during successive cutting ranged from approximately 20 to 60 gm. It showed that intermittent cutting produced a greater cutting effectiveness (for example, cutting volume per cut contact time) when carbide burs were used on dentin, compared with continuous cutting. It is recommended that the intermittent cutting procedure be used during work on patients.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
