Studies of the effect of fiber surface and matrix rheological properties on nonwoven reinforced elastomer composites

Abstract

AbstractThe influence of fiber type and fiber‐surface properties on matrix flow behavior was investigated using structural reaction injection‐molding (SRIM). The influence of fiber type, fiber‐surface properties, and matrix type on strength properties in elastomeric composites reinforced with nonwoven fibrous structures was investigated using tensile tests on elastomer composite samples from SRIM and latex coagulation (LC) fabrication methods and the microbond strength method on individual fibers. The fibers used were PET, LLDPE, and p‐aramid. Fibers were treated with epoxy, styrene, and isocyanate derivatives, which make the surface chemically reactive. Treatments were also made with NaOH and a copolymer of polyester and polyol ether, causing a change in the fiber surface energy. The matrix types were polyurethane elastomer and natural rubber. The results show that the surface treatments which produced a change in the surface energy influenced the flow rate of the matrix polymer during the composite fabrication process. The treatments resulted in chemically reactive fiber surfaces which improved the fiber‐matrix bond strength without affecting the Young's modulus of the composite material. Good correlation was found between bond strength and surface energy including the dispersive component of surface energy in the case of polyurethane elastomer and surface‐modified PET fibers. The age of the polyurethane matrix has a marked influence on the bond strength. The fiber volume fraction in composites has a strong influence on the Young's modulus of the elastomer composite. © 1995 John Wiley & Sons, Inc.