Structure optimisation of short-wavelength ridge-waveguide InGaN/GaN diode lasers

Abstract

AbstractRoom-temperature (RT) continuous-wave (CW) operation of the 405-nm ridge-waveguide (RW) InGaN/GaN quantum-well diode lasers equipped with the n-type GaN substrate and two contacts on both sides of the structure has been investigated with the aid of the comprehensive self-consistent simulation model. As expected, the mounting configuration (p-side up or down) has been found to have a crucial impact on the diode laser performance. For the RT CW threshold operation of the otherwise identical diode laser, the p-side up RW laser exhibits as high as nearly 68°C maximal active-region temperature increase whereas an analogous increase for the p-side down laser was equal to only 24°C. Our simulation reveals that the lowest room-temperature lasing threshold may be expected for relatively narrow and deep ridges. For the structure under consideration, the lowest threshold current density of 5.75 kA/cm2 has been determined for the 2.2-μm ridge width and the 400-nm etching depth. Then, the active-region temperature increase was as low as only 24 K over RT. For wider 5-μm ridge, this increase is twice higher. An impact of etching depth is more essential for narrower ridges. Quite high values (between 120 and 140 K) of the characteristic parameter T0 convince very good thermal properties of the above laser.