Abstract
Fluorocarbon coatings were deposited on the surface of regenerated cellulose films by RF magnetron sputtering, using polytetrafluoroethylene targets. Argon was used as the working gas. The coatings were characterized by X-ray photoelectron spectroscopy, Fourier transform infrared spectroscopy, atomic force microscopy, and static contact angle and oxygen permeability measurements. It was found that the coatings were made up of the four components -CF3, -CF2-, -CF- and -C-. The [F]/[C] ratio varied with sputtering conditions. The static contact angle of the coatings was greater than 90° at lower power and higher pressure, and the substrate material was transformed from hydrophilic to hydrophobic character. The fluorocarbon coatings were porous and did not influence the oxygen permeability of the cellulose film substrates.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
