Abstract
Zinc oxide (ZnO) powder was investigated in terms of its use as filler in order to improve the inherent properties of PLA. Biocomposite films of PLA with different loadings of ZnO were prepared by solution casting method. Morphological analyses using SEM and POM showed that the ZnO particles were well dispersed at low ZnO loading, with starfish-like morphology. However, ZnO agglomeration was found at higher ZnO loadings. Tensile testing showed improvements in strength and a moderate improvement in toughness at 2wt% ZnO loading. This is consistent with the homogeneous dispersion of ZnO particles in the PLA matrix. ZnO particles incorporation improved the thermal stability of PLA. In summary, ZnO particles were shown to have the potential as a toughener in the preparation of biocomposites with better integrity, although other approaches, such as the use of compatibilizer in the surface modification of ZnO will be needed for the concurrent improvement of PLA properties.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Biological Macromolecules
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.