Structure and properties of a microduplex maraging steel

Abstract

A simple two-step thermal processing technique was devised to impart a microduplex structure in a high-strength 250-grade commercial maraging steel. A martensite grain size of approximately 1 ..mu..m was obtained with interspersed islands of retained austenite whose volume fraction and mechanical stability could be controlled by varying the thermal processing conditions. The microstructure and mechanical properties of the microduplex structure were compared to those of the alloy in the maraged, martensitic condition. Due to the presence of the austenite phase, the microduplex structure showed a much smaller temperature and strain rate dependence of deformation than the martensitic structure. A remarkable increase in uniform elongation was observed below the M/sub d/ temperature of retained austenite. The microduplex structure did not show any significant advantage in fracture toughness over the martensitic structure when compared at similar strength levels. By suitably adjusting austenitic stability a deformation-induced phase transformation (TRIP) of the retained austenite in the microduplex structure could be made to occur; however, the transformation did not lead to any evident increase in toughness. The microduplex structure exhibited a slight improvement in fracture toughness at high strain rate, in contrast to the martensitic structure in which the rate effect significantly reduced the toughness.more » 10 figures, 3 tables.« less