Structure and mechanical properties of as-cast Ti–Si alloys

Abstract

In the present work, the microstructure and mechanical properties of as-cast Ti–Si alloys with a Si content ranging from 1 to 12.5 wt% prepared using a dental cast machine were investigated and compared with commercially pure titanium (c.p. Ti). X-ray diffraction (XRD) for phase analysis was conducted using a diffractometer. Three-point bending tests were performed to evaluate the mechanical properties of all specimens and their microstructure and fractured surfaces were observed using scanning electron microscopy (SEM). Experimental results indicated that the diffraction peaks of the Ti–Si alloys matched those of α-Ti and Ti5Si3. All the Ti–Si alloys had higher bending strengths and bending moduli than those of c.p. Ti. For example, the bending strength of Ti–5Si was about 2.6 times that of c.p. Ti, and both Ti–10Si and Ti–12.5Si had the highest bending moduli, which were about 1.8 times higher than that of c.p. Ti. Additionally, Ti–1Si exhibited ductile properties and Ti–3Si and Ti–5Si had a combination of brittleness and ductility. When the Si content was 7.5 wt% or greater, the alloys showed brittle properties. Judging from the results of the mechanical properties and deformation behavior, Ti–1Si, Ti–3Si, and Ti–5Si can be considered highly feasible alloys for prosthetic dental applications if other properties necessary for dental casting are obtained.