Abstract

In this research, nano-sized powders of Zr–Mn substituted strontium hexaferrite (Sr(Zr,Mn) x Fe12−2x O19 (x = 0, 2, 2.5, 3)) were synthesized by sol–gel auto-combustion route using subsequent heat treatment. The samples were characterized using X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), field emission scanning electron microscope (FESEM), transmission electron microscopy (TEM), Mössbauer spectroscopy and vibration sample magnetometer (VSM) techniques. XRD and Mössbauer spectroscopy results revealed formation of Sr(Zr,Mn) x Fe12−2x O19 accompanied with Mn δ Fe2−δ O4 lateral phase in the samples. Also, FTIR and XRD results demonstrated presence of SrO impurity phase. FESEM micrographs show particle size reduction and presence of two distinct powder morphologies with different brightness levels with Zr4+ and Mn2+ substitutions which approves existence of lateral phases in the substituted samples. TEM micrographs show nanometric particles with sizes smaller than 100 nm with high crystallinity. Mössbauer results showed that at low level of substitution, Zr4+ ions prefer to occupy both 4f1 and 2b however, at higher level of substitution, they prefer exclusively 4f1 site. While, Mn2+ ions distributed approximately equally between 12k and 2a sites. The presence of nonmagnetic Zr4+ cation leads to decrease in exchange interaction, especially at 12k and 2a sites. VSM results showed decrement of coercivity force ( i H c ) from 5593.60 to 3282.46 Oe and maximum magnetization from 62.60 to 46.15 emu g−1, respectively, by increment of Zr–Mn substitution values. Variations in maximum magnetization magnitude have been explained on the basis of occupation of the substituted cations at different iron sites.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.