Abstract

The influence of the wing root junction on the laminar separation bubble forming on the suction surface of a semispan NACA 0018 wing cantilevered from the wind tunnel test section wall is studied using surface flow visualisations, particle image velocimetry and surface pressure measurements at a chord Reynolds number of 125 000 and an angle of attack of 6 $^\circ$ . The test section wall boundary layer upstream of the wing is turbulent, and the spanwise influence of the junction on the separation bubble extends well beyond the test section wall boundary layer thickness. Substantial three-dimensionality is seen in the separation bubble flowfield near the wing root, where earlier transition and a reduction in separation bubble thickness is observed. In contrast with the wing tip, earlier transition and a reduction in separation bubble length occurs near the wing root. Outside of the junction affected region, the separation bubble is similar to separation bubbles forming on two-dimensional geometries, and displays mild spanwise waviness. The transition process away from the end affected regions is characterised by the formation of spanwise roll-up vortices that are shed in a nearly two-dimensional manner across the span. The analysis of the results shows that, near the wing root, the increased level of perturbations leads to earlier vortex roll-up and spanwise flow contributes to more rapid vortex breakdown. The results in the wing root region are complemented by the analysis of data from Toppings and Yarusevych (J. Fluid Mech., vol. 929, 2021, A39) in the wing tip region to provide a more holistic outlook on the laminar separation bubble topology and dynamics on the entire finite wing.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.