Abstract

The intracellular ability of the "10-23" DNAzyme to efficiently inhibit expression of targeted proteins has been evidenced by in vitro and in vivo studies. However, standard conditions for kinetic measurements of the DNAzyme catalytic activity in vitro include 25 mM Mg2+, a concentration that is very unlikely to be achieved intracellularly. To study this discrepancy, we analyzed the folding transitions of the 10-23 DNAzyme induced by Mg2+. For this purpose, spectroscopic analyzes such as fluorescence resonance energy transfer, fluorescence anisotropy, circular dichroism, and surface plasmon resonance measurements were performed. The global geometry of the DNAzyme in the absence of added Mg2+ seems to be essentially extended, has no catalytic activity, and shows a very low binding affinity to its RNA substrate. The folding of the DNAzyme induced by binding of Mg2+ may occur in several distinct stages. The first stage, observed at 0.5 mM Mg2+, corresponds to the formation of a compact structure with limited binding properties and without catalytic activity. Then, at 5 mM Mg2+, flanking arms are projected at right position and angles to bind RNA. In such a state, DNAzyme shows substantial binding to its substrate and significant catalytic activity. Finally, the transition occurring at 15 mM Mg2+ leads to the formation of the catalytic domain, and DNAzyme shows high binding affinity toward substrate and efficient catalytic activity. Under conditions simulating intracellular conditions, the DNAzyme was only partially folded, did not bind to its substrate, and showed only residual catalytic activity, suggesting that it may be inactive in the transfected cells and behave like antisense oligodeoxynucleotide.

Highlights

  • The typical DNAzyme,1 known as the “10 –23” model, has tremendous potential in gene suppression for both target validation and therapeutic applications [1]

  • To characterize structural changes in the DNAzyme, we performed fluorescence resonance energy transfer (FRET) analysis, which allowed us to monitor general folding of the molecule based on the measurements of distances between fluorophores linked to 5Ј and 3Ј side bases, and surface plasmon resonance analysis of the DNAzyme binding to its RNA substrate

  • Enzymatic Characteristics of the DNAzyme to ␤3 Integrin Subunit—The 10 –23 DNAzyme used in these studies was designed to cleave ␤3 integrin subunit mRNA, and preliminary characterization was done in our recent work [2]

Read more

Summary

EXPERIMENTAL PROCEDURES

Synthesis of DNAzyme to ␤3 mRNA—DNAzyme was chemically synthesized on a solid support using an ABI-394 DNA synthesizer, as described previously [13]. The fluorescence anisotropy of the fluorescein and rhodamine probes attached to the DNAzyme (Fluo-MeO-␤3DE[15]-Rhod, Fluo-MeO␤3DE[11]-Rhod) was monitored in an LS-50 spectrofluorometer (PerkinElmer Life Sciences) equipped with an automatic anisotropy measuring device. Surface Plasmon Resonance—The kinetic parameters (association and dissociation rate constants, kon and koff, respectively) and the affinity constant (KD) between DNAzyme and the mRNA substrate were measured by surface plasmon resonance using a BIAcoreX (Amersham Biosciences). DNAzyme flowed in two channels of the sensor; the first one contained the RNA substrate attached to avidin, and the second was without the RNA substrate The latter was used to correct SPR traces and remove the background binding between DNAzyme and the immobilized avidin on the dextran. The sensor chip was regenerated with three 10-␮l pulses of 12.5% formamide

RESULTS
TABLE II
DISCUSSION
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call