Structural, physical and mechanical changes of cement-bonded particleboards during sudden fluctuations in temperature and moisture

Abstract

The paper presents research focused on behaviour of cement-bonded particleboards with modified composition during sudden changes of temperature and humidity. Four types of boards were made—one control and three modified ones. Finely ground limestone was used as a modifying component in binder. Secondary wood particles made from crushing cuttings of cement-bonded particleboards were used as chips substituent. Two sets of test specimens (1 set = 6 test specimens) were manufactured. The first set was stored in laboratory conditions. The second set was subjected to 10 cycles of sudden changes of temperature (− 20 °C to + 70 °C) and humidity in accordance with EN 321 (further in the paper referred to as “wet–frost–dry cycle”.) After each cycle, dimensions and mass of the test specimens as well as ultrasonic pulse velocity were determined. A detailed analysis of structural changes in boards during cycling was carried out by an optical microscope. After 10 wet–frost–dry cycles were completed, bending strength and modulus of elasticity in bending were determined. The analysis of test results implies a very good relation between change of ultrasonic pulse velocity and width of cracks in the area of interfacial zone between cement matrix and wood particles. This finding also corresponds with dimensional and volumetric changes of the boards. Dependence of bending strength and modulus of elasticity in bending on composition of boards is apparent. Positive influence of secondary spruce chips on dimensional changes of cement-bonded particleboards caused by sudden changes of temperature and humidity was proved. Finely ground limestone contributes to more resistant structure of boards which leads to improved bending properties. Adverse conditions had more considerable influence on bending strength (decrease by 21% to 26%) than on modulus of elasticity in bending (decrease by 12% to 19%).