Abstract
This study highlights the structural, morphological, photovoltaic and electron transport properties of zinc oxide-multi-walled carbon nanotubes (ZnO-MWCNTs) based dye-sensitized solar cell (DSSC) prepared at different concentrations of 0.0, 0.1, 0.3 and 0.5 wt.%. The ZnO-MWCNTs thin films were prepared by a chemical bath deposition method. X-ray diffraction (XRD) analysis proved the formation of hexagonal wurtzite of the samples. The crystallite sizes, D of ZnO-MWCNTs was measured varies from 21 nm to 11 nm. The oat-like ZnO nanoflakes structure and the presence of MWCNTs were captured by field-emission scanning electron microscopy (FESEM) analysis. Transmission electron microscopy (TEM) analysis measured the inner (~6.81 nm) and outer (~28.31 nm) diameter of MWCNTs. The optimum concentration of 0.1 wt.% MWCNTs produced the highest photocurrent density, Jsc of 13.5 mA/cm2, open-circuit voltage, Voc of 0.149 V, fill factor, FF of 0.406 and power conversion efficiency, PCE of 0.817 %. Optimum doping of 0.1 wt.% MWCNTs generated short electron lifetime, τeff of 0.67 ms, low effective electron chemical diffusion coefficient, Deff of 9.5 x 10-8 cm2 s-1 and higher electron recombination rate, keff of 1497.48 s-1. The addition of MWCNTs has influenced the structural, morphological, photovoltaic and electron transport properties of ZnO-MWCNTs based DSSC.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.