Structural Geometry of a Sector of the Colorado River Delta, Baja California, Mexico, Based on Seismic Reflections

Abstract

A structural study in the SW section of the Colorado River delta using seismic reflection data is presented. The study area is located along the Cerro Prieto transform fault, which extends from the northern Gulf of California through the Mexicali Valley and is an active fault within the Pacific-North American plate boundary zone. The research was supported by a database of five seismic profiles with a total length of 215 km, collected in the early 80’s by Petroleos Mexicanos. The results show a high density of faults, most of which are buried by sediments. Within the Cerro Prieto fault zone, several faults were identified, such as: Palmas, Mesa, and Pangas Viejas, until now unknown. In addition, even though the Indiviso fault was investigated and superficially identify prior to this work, herein mapped at depth. West of the Cerro Prieto fault zone lies the Las Tinajas basin, bound by the Dunas and Saldana faults and by the Montague basin to the southeast. The deformation zone along the plate boundary is 18-km-wide, stretching from the Cerro Prieto fault in the east to the Pangas Viejas fault in the west. The orientations of the faults are NW–SE, and if projected from the southern side of the Sierra Cucapah southward, the faults tend to join the Cerro Prieto fault. In the Las Tinajas basin, the acoustic basement is deeper than 5,000 m. Some of the largest vertical displacements generated by the 2010 7.2-Mw El Mayor-Cucapah earthquake occurred southeast of the epicenter and coincided with the location of the Pangas Viejas Fault, which is buried by sediments. Before this event, seismic activity was very low, and no structures were known in the area. In this paper, we demonstrate that there are at least seven major faults that may now pose a high seismic hazard.