Structural features of Ni-Cr-Si-B materials obtained by different technologies

E E Kornienko,V I Kuz'Min,A S Ivashutenko,D V Lazurenko,N S Belousova,A A Nikulina

doi:10.1088/1757-899x/156/1/012020

E E Kornienko, V I Kuz'Min + Show 4 more

Open Access

https://doi.org/10.1088/1757-899x/156/1/012020

Copy DOI

Abstract

This study considers the structural features of Ni-Cr-Si-B (Ni - base; 15.1 % Cr; 2 % Si; 2 % B; 0.4 % C) materials obtained by different methods. The self-fluxing coatings were deposited by plasma spraying on the tubes from low carbon steel. Bulk cylinder specimens of 20 mm diameter and 15 mm height were obtained by spark plasma sintering (SPS). The structure and phase composition of these materials were investigated by optical microscopy (OM), scanning electron microscopy (SEM), transmission electron microscopy (TEM) and X-ray diffractometry (XRD). The major phases of coatings and sintered materials are γ-Ni, Ni3B, CrB and Cr7C3. We demonstrate that the particle unmelted in the process of plasma spraying or SPS consist of γ-Ni-NEB eutectic and also CrB and Cr7C3 inclusions. The prolonged exposure of powder to high temperatures as well as slow cooling rates by SPS provide for the growth of the structural components as compared to those of plasma coatings materials. High cooling rates at the plasma spraying by melted particles contribute to the formation of supersaturated solid solution of Cr, Si and Fe in γ-Ni. The structure of the melted particles in sintering material has gradient composition: the core constituted of Ni grains of 10 μm with γ-Ni-Ni3B eutectic on the edges. The results of the experiment demonstrate that the sintering material has a smaller microhardness in comparison with plasma coatings (650 and 850 MPa, respectively), but at the same time the material has higher density (porosity less than 1 %) than plasma coatings (porosity about 2.. .3 %).

Highlights

The self-fluxing alloys of Ni-Cr-Si-B system possess high wear resistance [1,2,3,4,5,6,7] and corrosion resistance [2,3,4,5, 8,9,10] at room and higher temperatures and high heat resistance [1, 3]
The structure of plasma coatings is presented in figure 1
X-ray analysis showed that the phase composition of coatings and sintering materials are the same

Summary

Introduction

The self-fluxing alloys of Ni-Cr-Si-B system possess high wear resistance [1,2,3,4,5,6,7] and corrosion resistance [2,3,4,5, 8,9,10] at room and higher temperatures and high heat resistance [1, 3] Due to these properties, machine details made of these materials are widely used in aerospace industry and aircraft construction [11], atomic [3, 12, 13], oil and chemical industry, and metallurgy [14]. The solution to of this problem is subsequent melting of self-fluxing coatings [2, 5, 7, 18]

Methods

Results

Conclusion