Abstract
Composites of a mixed type, consisting of porous piezoceramics particles in a polymer matrix, were produced and studied. A fabrication technique of such composites with 0–3 and 1–3 connectivities suitable for 3D printing method was presented. Their dielectric, electromechanical, and piezoelectric characteristics were measured. Dependences of dielectric permittivity on the number of layers of piezoceramic particles in the composite sample and on the ratio between the particle size and piezoelement thickness were presented. Single layer composites with appropriate ratio of the sample thickness and piezoelectric particles diameter demonstrated piezoelectric and electromechanical properties close to those of the initial piezomaterials.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
