Structural Effects on ORR Performances of Carbon-Free Connected Platinum–Cobalt Catalysts with Chemically Ordered Superlattice Structures

Abstract

Polymer electrolyte fuel cells (PEFCs) have been considered as the promising next-generation energy-conversion technology, owing to their high energy efficiency and clean emissions. However, a sluggish oxygen reduction reaction (ORR) rate and the low durability of conventional catalysts in PEFCs limit the wider commercialization. To address these issues, our group has developed a carbon-free, connected Pt1–Fe1 catalyst with a porous hollow capsule structure. This catalyst comprises the nano-sized network formed by the connection of Pt1–Fe1 nanoparticles and exhibits an enhanced ORR specific activity (9 times higher than a commercial Pt/C) as well as excellent durability against start-stop operations due to the carbon-free structure.[1,2] However, during the load cycle operation, iron is dissolved from the catalyst, leading to the loss of ORR activity and the degradation of polymer electrolytes caused by the Fenton reaction.In this work, carbon-free and iron-free connected Ptx-Co1 catalysts with chemically ordered superlattice structures have been developed for the first time, as shown in Fig. 1(a). In addition, the metal compositions and chemically ordered (superlattice) degrees in the catalysts were controlled to investigate the structural effects on ORR activity and durability of the connected Ptx-Co1 catalysts.Herein, we employed the silica-coating method for the catalyst synthesis, which involves the combination of silica coating and high-temperature annealing. As shown in Fig. 1(b), the surface of the Ptx-Co1 nanoparticles/SiO2 sample was coated with thin silica layers to prevent the detachment of Ptx–Co1 nanoparticles from the SiO2 template as well as the large catalyst agglomeration and coalescence during the annealing process. We controlled the chemically ordered degrees of the connected Pt1–Co1 and Pt3–Co1 catalysts by using different annealing temperatures. The XRD patterns of the catalysts showed the peaks corresponding to L10 type and L12 type chemically ordered structures for the connected Pt1–Co1 and Pt3–Co1 catalysts annealed at 600°C, respectively. These two catalysts possessed ordered degrees (S) of ca. 50–60%. The TEM images of the connected Ptx–Co1 catalysts showed the formation of connected Ptx–Co1 nanonetwork and porous hollow capsule structures.The electrochemical measurements of ORR activity and durability were conducted in a 0.1 M HClO4 electrolyte solution. The connected Pt1–Co1 and Pt3–Co1 catalysts achieved 6- and 10-times higher ORR specific activities than that of Pt/C, respectively. Subsequently, the ORR activity and load cycle durability (0.6 V for 3 s Û 1.0 V for 3 s at 60 °C) of the connected Pt3–Co1 catalyst with different ordered degrees (S = 0%, 28%, and 58%) were evaluated. As the ordered degrees in the connected Pt3–Co1 catalysts were higher, the ORR specific activity was increased. Also, the retention of the specific activity of the ordered catalyst (S = 58%) was higher than that of the disordered catalyst (S = 0%) after 10,000 load cycles. The STEM-EDX line mapping results showed that 83% of the alloyed Co retained in the catalyst with a higher ordered degree even after 10000 load cycles, whereas the disordered and lower ordered catalysts retained lower Co ratios after the test, indicating the suppression effect of an ordered structure on metal dissolution. In addition, the L12 ordered Pt3–Co1 structure remained in the connected catalyst (S = 58%) after load cycle test, confirmed by the TEM diffraction analysis.In summary, we successfully developed the connected Ptx-Co1 catalysts with chemically ordered superlattice structures. In addition, we clarified the structural effects of metal composition and ordered degree in connected Ptx-Co1 catalysts on ORR activity and load cycle durability. These results provide useful guidelines for the design of advanced ORR catalysts towards high-performance PEFCs. Acknowledgement The part of this presentation is based on results obtained from a project, JPNP20003, commissioned by the New Energy and Industrial Technology Development Organization (NEDO).