Structural characteristics and elevated temperature mechanical properties of AJ62 Mg alloy

Abstract

Structure and mechanical properties of the novel casting AJ62 (Mg–6Al–2Sr) alloy developed for elevated temperature applications were studied. The AJ62 alloy was compared to commercial casting AZ91 (Mg–9Al–1Zn) and WE43 (Mg–4Y–3RE) alloys. The structure was examined by scanning electron microscopy, x-ray diffraction and energy dispersive spectrometry. Mechanical properties were characterized by Viskers hardness measurements in the as-cast state and after a long-term heat treatment at 250°C/150hours. Compressive mechanical tests were also carried out both at room and elevated temperatures. Compressive creep tests were conducted at a temperature of 250°C and compressive stresses of 60, 100 and 140MPa. The structure of the AJ62 alloy consisted of primary α-Mg dendrites and interdendritic nework of the Al4Sr and massive Al3Mg13Sr phases. By increasing the cooling rate during solidification from 10 and 120K/s the average dendrite arm thickness decreased from 18 to 5μm and the total volume fraction of the interdendritic phases from 20% to 30%. Both factors slightly increased hardness and compressive strength. The room temperature compressive strength and hardness of the alloy solidified at 30K/s were 298MPa and 50 HV 5, i.e. similar to those of the as-cast WE43 alloy and lower than those of the AZ91 alloy. At 250°C the compressive strength of the AJ62 alloy decreased by 50MPa, whereas those of the AZ91 and WE43 alloys by 100 and 20MPa, respectively. The creep rate of the AJ62 alloy was higher than that of the WE43 alloy, but significantly lower in comparison with the AZ91 alloy. Different thermal stabilities of the alloys were discussed and related to structural changes during elevated temperature expositions.