Structural aspects of the attached turbulent boundary layer flow over a hill

Abstract

Three-dimensional turbulent boundary layers under strong pressure gradients and curvature are the rule in real-world flow applications but are typically not well predicted by turbulence models due to isotropic eddy viscosity or equilibrium assumptions. Validation-quality data in complex 3D flows is necessary for continued efforts to improve simulation accuracy. The Benchmark Validation Experiments for RANS/LES Investigations (BeVERLI) Hill bump model, designed specifically for validation experiments, was tested in the Virginia Tech Stability Wind Tunnel to collect validation experiment data on the three-dimensional (3D) boundary layer flow over a 3D hill. Laser Doppler velocimetry measurements on the bump model were used to study the mean flow and turbulence structure and evaluate the impact of pressure gradient and curvature upon the total shear stress in the boundary layer and evaluate the impact of pressure gradient and curvature upon the total shear stress behavior in the near-wall region. From analysis of the BeVERLI Hill flow, including the boundary layer just upstream of the hill, and comparison with the 3D flow around a wing-body junction of Ölçmen et al. (Exp Fluids 31:219–228, 2001), it is shown that none of the stations studied exhibit a constant shear stress region over any significant region of the boundary layer.Graphical abstract