Structural and electrical conductivity studies of Polyaniline - WO3 hybrid nanocomposites for gas sensing applications

Abstract

Abstract Conducting polymer – metal oxide based hybrid nanocomposites are a fascinating class of materials for miniaturized and flexible gas sensor devices. They exhibit enhanced physiochemical properties such as sensitivity, selectivity towards various volatile and hazardous chemical and bioanalytes. Our study focuses on conducting polyaniline (PANI) and WO3 nanocomposites, where different weight percentages (wt.%) of WO3 nanoparticles are embedded within the conducting PANI matrix using an in-situ oxidation polymerization synthesis technique. The surface morphology analysis indicated that the WO3 nanoparticles with an average grain size of ~200 nm are homogeneously distributed within the PANI nanofibers. The Fourier Transform Infra-Red (FTIR) spectrum analysis showed that the absorption peaks at 1111,1291, 1385, 1474, and 1560 cm−1 are typical of the conducting PANI emeraldine phase. We attribute the additional broad peak ranging between 840 to 720 cm−1 in the spectrum to WO3 phase, wherein, the intensity of the peak increases with WO3 content in case of hybrid composites. Current-voltage (I-V) characteristics for all our samples showed linear behaviour up to 1.2 volts. Temperature-dependent DC electrical conductivity (σ) studies measured from room temperature to 120°C for pure PANI, and PANI-WO3 composites showed an enhanced electrical conductivity of values up to 0.12 S/cm for PANI as compared to WO3 with σ ~ 1.4 x 10−3 S/cm. Pure PANI exhibits semiconducting behavior with an increase in electrical conductivity with temperature due to the charge carrier delocalization within the dispersed PANI backbone. The addition of higher concentrations of WO3 in composites leads to a metallic-like behavior, characterized by a decrease in electrical conductivity with temperature. These observations are attributed to the field-assisted band bending effects at the interfaces of PANI and WO3. Our composites show desired electrical characteristics suitable for gas sensing applications.