Striped‐pattern deterioration and morphological analysis of injection moldings comprising polypropylene/ethylene α‐olefin rubber blends. I. Influence of ultraviolet irradiation

Abstract

AbstractUnique deterioration with a periodical striped pattern on the injection moldings of polypropylene/rubber blends is reported. After exposure to ultraviolet irradiation with a sunshine fade meter, striped patterns appeared on the injection moldings along the flow direction of the molten resin during the filling process of injection molding, even though the initial specimen showed no sign of any stripe pattern on its surface. The stripe was carefully observed with ultrasonic echo imaging, scanning electron microscopy, transmission electron microscopy, and Fourier transform infrared spectroscopy. As a result, a number of microvoids were observed inside the injected body at a depth of 50–100 μm from the surface. It became clear that the difference in the number of voids along the flow direction formed the stripe pattern. Surprisingly, these voids occurred in domains comprising a rubber phase. The distribution of voids in depth indicated the existence of a trace of a snakelike flow caused inside the injected body during the injection‐molding process. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2007