Abstract
The article presents an analysis of the stress state of workpieces during upsetting of workpieces with an additional shear. For the analysis, the slip line method and the finite element method were used. A schematic diagram of upsetting in dies with “floating” elements, contributing to the implementation of additional shear, reduction of barreling, inhomogenous deformation and contour tensile stresses, is presented. The analysis of the research results showed that during upsetting of workpieces with additional shift forces, tensile stresses on the side surface of the workpieces decrease, which excludes the appearance of cracks on the side surface of the samples, especially when processing low-plastic alloy steels and alloys, and also reduces the barreling of the side surface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.