Abstract
AbstractDimensionless stress intensity factors were determined for single-edge-crack solid and hollow round bars loaded in tension. These factors were calculated from experimental compliance (inverse slope of load-displacement curve) measurements made over a range of dimensionless crack depths (lengths) from 0.05 to 0.65. The tests were made with 76-mm (3-in.) diameter solid and hollow round bars notched on one side and loaded in axial tension. The hollow bar had an inner to outer diameter ratio of 0.33. A comparison was made with data in the literature for rectangular bars; for a crack depth to diameter ratio of 0.0001 the dimensionless stress intensity factor for a solid round bar is 0.55 compared with 2.0 for a rectangular bar.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.