Abstract
Determination of strain in resonant column and torsional shear (RC/TS) tests is complicated due to nonuniform stressโstrain variation occurring linearly with the radius in a soil specimen in torsion. The equivalent radius approach is adequate when calculating strain at low to intermediate levels, however, the approach is less accurate when performing the tests at higher strains. The stress integration approach involving integration of an assumed soil stressโstrain model was developed to account for this problem more precisely. This approach was used to generate the plots of equivalent radius ratio versus strain developed based upon shear modulus and damping. Results showed that the equivalent radius ratio curves converge to a value of approximately 0.8 at low strains and decrease as strain increases. The equivalent radius ratio curves based upon damping decrease to significantly lower values at high strain than curves based upon shear modulus. This study suggests that using the same values of equivalent r...
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Geotechnical and Geoenvironmental Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.