Abstract
Excessive crosstie wear and abrasion and ballast wear and fouling are fundamental problems contributing to inadequate railroad track performance. This adversely affects the attainment and long-term maintenance of desired track geometric requirements. The magnitudes and distribution of the stresses at the crosstie–ballast (CT-B) interface must be known to determine the stress distribution on and within the ballast. However, the track design recommendations to determine these pressures, which are largely based on a methodology from the 1980s, are currently valid for modern-day railroad applications for multiple reasons discussed in this study. This study analyzed CT-B interfacial pressure data measured on an active freight mainline in Mascot, Tennessee. Dynamic contact pressures at the CT-B interface were measured using hydraulic earth pressure cells for various wheel loads and train speeds. The test train was a Federal Railroad Administration (FRA) test train consisting of a diesel electric locomotive, a test car that had different wheel loads based on the deployable axle load, and an inspection car. Although the maximum train speed was limited to 64 km/h, this research found that speed variation has a minimal effect on the CT-B interfacial pressures. From the measured data, a Gaussian stress distribution equation is proposed to determine longitudinal pressure distribution transmitted to the CT-B interface for static conditions. In addition, the stress distribution along the length of a crosstie was investigated via laboratory experimentation using a half-length crosstie. As a result of the experimentation, a dimensionless trilinear approximation was developed to estimate the stress distribution along the length of the crosstie. In general, this research recommends that the longitudinal and lateral stress distributions be considered together to design a better railroad track.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Transportation Engineering, Part A: Systems
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.