Stress concentration of a strip with double edge notches under tension or in-plane bending

Abstract

The stress concentration analysis of 60° V-shaped or partially-circular double edge notches in an infinite strip under tension or in-plane bending is discussed. The stress field induced by a point force in an infinite plate is used to solve these problems. The present results for semicircular notch are in close agreement with other reports. The results calculated on the 60° V-shaped notches show that the Neuber formula gives an underestimated stress concentration factor of about 11% for tension case and in about 9% for bending case. These errors exist for a wide range of notch depth. However, in the case of blunt notches, the Neuber solution of deep hyperbolic notches still gives a sufficient accuracy in engineering use. In addition, the stress concentration factors of 60° V-shaped notches are also represented by diagrams for wide use.