Abstract
In the present work an attempt has been made to analyse the stress developed on the surface of Pelton bucket using Mechanical APDL. The geometric modelling of this bucket has been done using CATIA software for a 50 m head and stress analysis has been done in Mechanical APDL. The stress analysis has been done considering bucket as a cantilever element fixed to the disc at one end with the force of jet applied at the splitter. The stress analysis has been done for flow rates ranging from 100 lit/sec to 150 lit/sec and speed ranging from 700 rpm to 900 rpm. It is observed that 1st principle stress is higher than 2nd principle stress and 3rd principle stress. Von Mises stress as well as all three principle stresses decreases as rotational speed of pelton wheel increases.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Asian Journal of Engineering and Applied Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
