Abstract
It is shown that polymerization and thermomechanical stresses are important in miniaturized chip on board (COB) modules. COB technology is reliable enough to meet most of the demands from the market if the manufacturer has the process perfectly under control. There are two methods to check finite element method and ensure reliability of such miniaturized structures: (FEM) simulation and measurements with test die. FEM allows predictive calculations of stress which are verified by experiment. The FEM allows easy optimization during the design phase and provides a powerful tool to ensure the quality and reliability of low cost COB multichip modules. >
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.