Strengthening mechanisms in nanostructured interstitial free steel deformed to high strain

Abstract

In this study, the strengthening mechanisms in nanostructured IF steel deformed to high strain by four-layer accumulative roll bonding (ARB) process at room temperature in absence and presence of SiC particles were investigated. Microstructural observations were performed by scanning electron microscopy (SEM) and scanning transmission electron microscopy (STEM). The results indicated that the average grain size of the pure steel, composite, and nanocomposite was 95, 73, and 55nm, respectively and the microstructures consisted of equiaxed grains. Also, with increasing the number of ARB cycles, the dislocation density of samples increased. The first cycle of ARB process had remarkable effect on the dislocation density. The value of dislocation density first rapidly increased, then dwindled, and finally saturated by further ARB cycles. The presence of SiC microparticles and nanoparticles in the IF steel matrix increased the dislocation density during the ARB process. On the other hand, dislocation density of the nanocomposite was higher than that of the composite. After first cycle, a significant increase observed in the yield strength, from 84MPa to 609, 682, and 689MPa for pure steel, composite, and nanocomposite, respectively, which was almost 7.3, 8.1, and 8.2 times greater than that of the initial sample. There was no perfect saturation in yield strength of the pure IF steel with increasing the number of ARB cycles. Finally, the contribution of individual mechanisms such as the grain refinement, dislocation, second phase, and precipitation in strengthening of the IF steel was evaluated. The contribution of grain refinement and precipitation to the improvement in yield strength was maximum (~67–72%) and minimum (~3.1–3.7%), respectively.