Abstract
This work aims to evaluate the feasibility of the fabrication of nanostructured Cu/Al/Ag multi-layered composites by accumulative roll bonding (ARB), and to analyze the tensile properties and electrical conductivity of the produced composites. A theoretical model using strengthening mechanisms and some structural parameters extracted from X-ray diffraction is also developed to predict the tensile strength of the composites. It was found that by progression of ARB, the experimental and calculated tensile strengths are enhanced, reach a maximum of about 450 and 510 MPa at the fifth cycle of ARB, respectively and then are reduced. The electrical conductivity decreased slightly by increasing the number of ARB cycles at initial ARB cycles, but the decrease was intensified at the final ARB cycles. In conclusion, the merit of ARB to fabricate this type of multi-layered nanocomposites and the accuracy of the developed model to predict tensile strength were realized.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Transactions of Nonferrous Metals Society of China
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.