Abstract
In this paper, a new assembling method of spline joints that enables tight fitting in a simple manner by allowing slight plastic deformation at the spline teeth was introduced. Experiments were carried out for the spline joints of medium carbon steel varying the overlap zone between the male and the female spline teeth. Axial joining strength was increased with increase in the overlap length due to the residual compressive stress by forming. The joint by the proposed method also showed higher torsional strength than the conventional joint. Improvement in the torsional strength was explained based on the deformation and hardness distribution around the spline teeth. With respect to the shape of overlap zone, better results were obtained when using the specimen having a uniform overlap length along the axial direction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
