Strength and compressibility of Abqaiq marl, Saudi Arabia

Abstract

The increasing number of construction projects and the lack of good quality soil for use in these projects in eastern Saudi Arabia necessitate the use of available marginal soils. Most, if not all, engineering projects use the fine-grained calcareous sediments, known locally as marl, either as a foundation material or as a fill material. The lack of published information on their engineering characteristics and behavior under ambient conditions has resulted in many construction and post-construction problems. This investigation is one of a series to evaluate the geotechnical properties of selected marl soils obtained from different areas in eastern Saudi Arabia. Marl samples, obtained from Abqaiq, were prepared in the laboratory under controlled conditions and subjected to different tests including CBR (soaked and unsoaked), triaxial compression, unconfined compression and one-dimensional compression tests. Samples were prepared at different moisture contents on both the wet and dry sides of optimum. X-ray diffraction analysis indicates that this marl contains high percentages of dolomite and calcite, in addition to other materials. The molding water content significantly affects the engineering properties of this material. Compaction on the dry side of optimum resulted in samples that have some swelling potential and highly compressible characteristics when subjected to a load after inundation.