Strain-Induced Austenitic Structure in Microalloyed Steels

Abstract

Abstract Austenite morphology is one of the main factors determining austenite-ferrite transformation kinetic and effectively affects the final microstructure and properties. The basic criteria for proper assessment of the austenite transformation products, theirs refinement, is the relation between the nucleation to growth rates. The main factor accelerating both, the nucleation rate of austenite during heating, and ferrite during cooling is the presence of accumulated deformation energy. The primary aim of this work is to increase our knowledge of the effects of deformation - its accumulated energy on the austenite structure and properties. Two specific steel grades were selected for the present investigation, i.e. microalloyed and IF steel, essentially different in equilibrium transformation temperatures. Obtained austenitic microstructures were analyzed, first of all as a start point for the austenite-to-ferrite transformation. Specific case of this transformation was considered i.e. Strain Induced Dynamic Transformation SIDT. The characteristic feature of the SIDT is the strong dependence of theirs kinetic on the austenite morphology, especially grain size. Thermomechanical processing, that utilize the SIDT, is one of the most effective ways to produce ultrafine-grained steel. One of the main benefits of the austenite refinement, just before the γ→α transformation, is its significant effect on the microstructure evolution during subsequent thermomechanical processing. Experimental results clearly show how direct and positive influence the austenite grain refinement has on the composition and refinement of transformation products. Presented study was focused on Strain Induced Dynamic Reverse Transformation. It is proved that this kind of transformation is very efficient way to intensify thermomechanical processing of microalloyed steels. Dynamic transformation kinetics were analyzed based upon flow curves recorded during the SIDT process. The main effect of presented research is analyze of influence of prior microstructure on dynamically formed austenite morphology