Abstract

Straining of sheet metal leads to surface roughness changes. In this study, foils of AISI 201 and AISI 304 stainless steel were strained in uniaxial tension to impose roughening of their surfaces. Thereafter, the corrosion resistance, electrical resistivity, magnetic field density, and lubricated friction of the resulting surfaces were evaluated. The effect of strain-rate on the surface roughening, and thereby on the friction against tools, corrosion resistance, and occurrence of deformation-induced martensite was investigated. The AISI 304 material showed higher roughening than AISI 201 at low strain-rate. Lubricated friction is clearly affected by the changes to the surface of the strained foils that occur. When simulating a micro-forming process, the effect of strain-induced changes should be included where possible to maintain a high fidelity of the simulation. Strain-rate, in the range tested in this work, had only a minor effect on corrosion properties; however, the martensite fraction was reduced for material elongated at higher strain-rates.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call