Abstract
Powder metallurgy (PM) nickel steels are often selected because they have high strength, high impact resistance and good abrasion resistance. The microstructure of slowly cooled PM nickel steels typically contains pearlite, bainite, martensite and a fair volume fraction of retained austenite. Since volume diffusion is really low at conventional sintering temperatures [1120–1150°C (≈2050–2100°F)], nickel rich areas are usually found where prior admixed nickel particles were located, i.e. at the surface of iron particles and in sintering necks. Therefore, there is a discrepancy between the rather low mechanical properties of austenite and the high strength of PM nickel steel. Hence, the hypotheses that stress induced or strain induced martensite formation takes place during mechanical testing have been investigated. Results show that martensite forms during mechanical testing, and its final volume fraction is proportional to nickel content.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
