Abstract
Abstract The potential of aluminum wires immersed in an electrolyte was followed after abrupt straining of 1.5–12%. The maximum potential achieved after straining in 0.1M NaCl decreased with decrease in pH and the rate of decay to the initial steady-state value was independent of pH over the range of 1.5–6.5. The presence of dissolved oxygen in the solution increased the rate of decay to the steady-state value. The different potential behavior of untreated wires, wires heated in boiling water, and anodized wires was attributed to different mechanical properties of the oxide. The strain electrometry curves were identical in solutions of NaCl, Na2SO4, sodium tartrate, and Na2Cr2O7 of equal ionic strength. The pertinence of the results to the behavior of aluminum exposed at the tip of a growing stress corrosion crack is discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.