Abstract
Sticking of H and D atoms on interstellar dust grains is the first step in molecular hydrogen formation, which is a key reaction in the InterStellar Medium (ISM). After studying the sticking coefficients of H2 and D2 molecules on amorphous silicate surfaces experimentally and theoretically, we extrapolate the results to the sticking coefficient of atoms and propose a formulae that gives the sticking coefficients of H and D on both silicates and icy dust grains. In our experiments, we used the King and Wells method for measuring the sticking coefficients of H2 and D2 molecules on a silicate surface held at 10 K. It consists of measuring with a QMS (quadrupole mass spectrometer) the signals of H2 and D2 molecules reflected by the surface during the exposure of the sample to the molecular beam at a temperature ranging from 20 K to 340 K. We tested the efficiency of a physical model, developed previously for sticking on water-ice surfaces. We applied this model to our experimental results for the sticking coefficients of H2 and D2 molecules on a silicate surface and estimated the sticking coefficient of atoms by a single measurement of atomic recombination and propose an extrapolation. Sticking of H, D, HD, H2, and D2 on silicates grains behaves the same as on icy dust grains. The sticking decreases with the gas temperature, and is dependent on the mass of the impactor. The sticking coefficient for both surfaces and impactors can be modeled by an analytical formulae S(T), which describes both the experiments and the thermal distribution expected in an astrophysical context. The parameters S0 and T0 are summarized in a table. Previous estimates for the sticking coefficient of H atoms are close to the new estimation; however, we find that, when isotopic effects are taken into account, the sticking coefficient variations can be as much as a factor of 2 at T=100 K.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have