Step height measurement of monoatomic silicon crystal lattice steps with a commercial atomic force microscope

Abstract

Abstract Precise control of advanced materials relies on accurate dimensional metrology at the sub-nanometre scale. At this scale, the accuracy of scanning probe microscopy (SPM) has been limited by the lack of traceable transfer standard artefacts with calibration structures of suitable dimensions. With the adoption in 2019 of the silicon crystal lattice spacing as a secondary realization of the metre in the International System of Units (SI), SPM users have direct access to a realization of the SI metre at the sub-nanometre level by means of the step height of self-assembled monatomic lattice steps that can form on the surface of silicon crystals. A key challenge of successfully adopting this pathway is establishing the need for established protocols to minimize measurement errors and artifacts in routine laboratory use.
In this study, step height measurements of monoatomic lattice steps in an ordinal/staircase structure on a Si(111) crystal surface have been derived from images acquired with a commercially available, research-level atomic force microscope (AFM). Measurement results derived from AFM images using three different SPM image processing and analysis software packages are compared. Significant sources of measurement uncertainty are identified; principally the contribution from the dependence on scan direction. The calibration of the
AFM derived from this measurment was used to traceably measure the sub-nanometre lattice steps on a silicon carbide crystal surface to demonstrate the viability of this calibration pathway.