Abstract
In the UV nanoimprinting process an antisticking layer such as fluorinated self-assembled monolayer (F-SAM) is grafted on the mold surface to diminish the demolding impact. These layers are supposed to deteriorate as the imprint steps mount up, resulting in defects in the cured resist layer. In this work, continuous multiple shots of UV nanoimprint were conducted in the air and in pentafluoropropane (PFP) gas environment and demolding forces in every imprint step were determined. The experiments revealed that the demolding forces for the imprint in PFP atmosphere drastically reduced compared with those in the air. Water contact angles of the mold surface were also determined in every 225 imprint steps to observe the degree of degradation of the antisticking layer. It was found that the antisticking layer was less damaged or contaminated in the PFP environment than it was in the air after a certain number of imprint steps.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
