Steady-state and transient characteristics of microcavity surface-emitting lasers with compressively strained quantum-well active regions

Abstract

In conventional semiconductor lasers, the dimensions of the optical cavity greatly exceed the photon wavelength, and the photon density of states forms a continuum since it is essentially that of a bulk system. On the other hand, in an ideal laser, one would like to have a single optical mode coincident with the maximum in the gain spectrum of the active medium. We show that substantial density-of-states quantization and enhancement of the fraction of photons spontaneously emitted into the lasing mode can be obtained by reducing the lateral width of the surface-emitting laser. For emission at /spl lambda/=0.954 /spl mu/m, the threshold current density can be drastically reduced by increasing the coupling factor to a few percent. For a cavity structure width of 0.3 /spl mu/m, the threshold current density is 50 A/cm/sup 2/, compared with 250 A/cm/sup 2/ for the 0.6-/spl mu/m cavity. At lower still lateral widths, the cavity loses its vertical character, and confinement of the lateral optical mode rapidly deteriorates. The large-signal response of microcavity lasers is slightly improved primarily due to elimination of mode competition in intrinsically single-mode microcavities, with relaxation times close to 1 ns. The enhancement of the spontaneous emission coupling factor results in an increase of the relaxation oscillation frequency and improvement in the standard small-signal response of microcavity lasers. For J=10J/sub th/, the -3 dB modulation frequency exceeds 40 GHz. Since low threshold current densities may be achieved in microcavity lasers, the gains in small-signal performance are primarily extrinsic, i.e., higher modulation bandwidths ace accessible for the same injection.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">&gt;</ETX>